 |  | 
Prostar Paintball and Techna Trigger have teamed up to bring you one of the best designed ION triggers on the market. The trigger is made of Acetron and incorporates many of the features that are unique to Techna Trigger designs (unique still even after four years of being copied by others). First is the ball bearing pivot. Like the Techna produced triggers, this one also uses dual specialized flanged bearings with extended inner rings. The bearing flanges ensure that no matter how many cycles, or how hard the use, the trigger body will NEVER "walk" off of the bearing to bind on the sides of the grip frame. The extended inner rings work to position the trigger body precisely within the frame so that at no point in its travel is the trigger permitted to rub the frame. Cycle after cycle, use after use, the bearings remain centered in the frame, and the trigger body centered in the bearings. This trigger incorporates a drop in and bolt in place, "digit" pivot pin. This pivot pin will allow you to install and remove the trigger without the fear of damaging the frame or the bearings through hammering. The pin simply pushes through frame and bearings with slight thumb pressure, and is then secured with a small button head screw. There are adjustments for over travel, switch take-up, and magnet tension, making it easy to dial in the trigger feel as well.
Heres what you get:
- Complete installation instructions
- Made of Acetron
- Dual bearings with extended extended inner rings installed
- Precision "Digit" pivot pin assembly
- 2 magnets that allow for three tension settings (no
magnet, 1 magnet or 2 magnets)
- Pre and post travel adjustments
- set screws are pre-applied with serviceable loctite
- .050 allen wrench
- 1/16 allen wrench
|
|
|
